2Volt 1200Ah Deep Cycle Gel Battery Long Service Life Series Connection

Description
Deep Cycle Gel battery is a battery in which the electrolyte is in gel state, which belongs to a development classification of lead-acid battery, the method is to add gelling agent to sulfuric acid, so that the sulfuric acid electrolyte becomes gel state. Deep Cycle Gel Battery is a kind of lead-acid battery. Deep Cycle Gel Battery is an improvement of the ordinary lead-acid battery with liquid electrolyte, replacing the sulfuric acid electrolyte with gel electrolyte, which improves the safety, storage capacity, discharge performance and service life compared with the ordinary battery.

Product Features

• Product name: Deep Cycle Gel Battery
• Capacity range: 100Ah-3000Ah
• Voltage class: 2V
• Float charge voltage: 2.23V-2.25V
• Equalized charge voltage: 2.35V-2.40V
• Long working life: 10years
• Low self-discharge rate: ≤3%/month
• High sealed reaction efficiency: ≥99%
• Widen operation temperature rang: -30℃~55℃
• AGM spacer with specific coarse to fine fiber ratio, incorporating colloidal electrolyte for long shallow cycle life.
• Special negative lead paste formula to prevent sulfation of negative electrode plate, improve charge acceptance capacity and charge/discharge performance.

Advantages

• Product name: Deep Cycle Gel Battery
• High safety, reliability and stability
• High quality, long cycle life
• Small self-discharge, good deep-discharge performance, strong charge acceptance, small up and down potential difference, large capacity.

Application

• UPS/EPS systems
• Communication System
• Power Plant and Transmission System
• Solar, wind power generation and wind and solar complementary energy storage systems, power systems, nuclear power plants standby power

Compliant standards

• IEC60896-2-1995
• TD/T 799-2010
• GB/T 19638.2－2005
• GB/T22473-2008
• YD/T1360-2005
• JISC8704-2:1999
• Passed ISO9001.ISO14001, GB/T28001-2001, CE,
• TLC, CGC certificate

Use of Deep Cycle Gel Battery

• Product name: Deep Cycle Gel Battery
• Check before charging and discharging: Before charging and discharging, the insulation of the charging equipment should be checked to see if it is good. Specific method: use 500V megohmmeter to measure the DC charging screen bus not less than 10MΩ.
• Initial replenishment of electricity: Before putting the battery into use after installation and inspection, it should be balanced and supplemented with 14.1V balanced charging voltage at 25℃ for a single battery, and charged in a constant voltage current-limiting way for the battery pack. The maximum charging current is set to 0.25C10A.

• Discharge: 1) 12V battery charging and discharging, 250Ah battery with a current of no more than 25A for 10 hours to discharge until the battery termination voltage of 10.8V or more, do not over discharge.
  2) During the discharge process, measure and record the battery voltage, discharge current and ambient temperature every hour, pay attention to the change of ammeter and battery voltage at any time, when the voltage drops to about 12.0V, change to half an hour test. When the measured voltage is 10.8v, stop discharging, open the discharge switch, the discharge is over. And record the discharge termination time, battery voltage, ambient temperature.
  3) After discharge, the battery should be recharged in time, to prevent acidification of the poles, the discharge-charging interval should not exceed 8 hours, so it must be balanced within 8 hours to replenish the electricity, the average charging voltage is set to 14.1V (the average of the measured value of the positive and negative terminals of the battery at 25℃), and the maximum charging current is set to 0.25C10A. The battery will run normally with the float charging voltage of 13.5V. Battery 13.5V.

  4) After discharge, check the discharge capacity at 25℃, it should be not less than 85% of the rated capacity, i.e. 12V250AH battery is not less than 212.5Ah.

• Temperature compensation: The above current and voltage setting values are the standard values when the ambient temperature is 25℃, if the gel battery working temperature is beyond the range of 20℃-30℃, the floating charge and average charge voltage should be corrected accordingly, the corrected voltage is, that is, for every 1℃ increase in temperature, the floating charge voltage is reduced by 5.5mV, and for every 1℃ decrease in temperature, the floating charge voltage is increased by 5.5mV.

Together with our customers and suppliers, we have been partners in solar battery industry for 12 years and have supplied over 20 kinds of patent solar systems for home and abroad.

In 2008, we established FairylandSolar^TM and won our first solar home system project--“GoldSun” project for whole Shaanxi province which was a famous big project appointed by Chinese government. During 3 years installation, we were always moved a lot when people showed true smile when lighting their home. They should carry a heavy battery and walk hours home, so aftersales is so difficult that pushes us to supply high quality products with long lifetime. We invested gel battery production line with a 50 staff team who has 20 years production experience for AGM battery. For the enough good quality and reasonable price, we becomes a stable supplier for solar projects, OEM for them.

In 2018, as the rapid development of lithium battery, we established CASISOLAR^TM that started a team only for packing lithium batteries. During the past 3years, we found the wide difference between price and products. As government promotes “ giving retied battery a second life” , some make a profit in troubled situation, providing retired cells for solar making great lost in a long term or even has personal safety hazard.

So in CASISOLAR, we don’t think it is 100% safe to use retired battery cells. We only accept cells at Great A with 5 years more warranty. We didn’t grow up quickly but we harvest every customer we have cooperated. We always enjoy and appreciate troubles met during every cooperation, and give great enthusiasm and confidence.

Our mission is to provide solar energy at low cost over a long lifetime.